TechniSat DIGITRADIO 451 CD IR

102
15.2 Internet seings
> You can access and configure the network seings via MENU > Main Menu > System Seings > Internet Seings.
15.2.1 Seing up a wireless connection
To configure the network connection via WLAN, you have the option of using the network wizard or
doing this manually.
15.2.1.1 Network wizard configuration
> Select [Network Wizard] to launch this.
The network wizard now searches for all the wireless networks within range and displays them.
> Select the WLAN network you recognise and then select the preferred connection method.
[Press buon] Start WPS function (please refer to the procedure for your router)
[PIN] Start WPS function with a PIN (please refer to the procedure for your router)
[Skip WPS] Enter the network key manually (you only need to enter it once)
Aer selecting [Skip WPS], you can enter the password using the on-screen keyboard. Then select the [OK] field. If the
password entered is correct, a connection to the network is now established. The signal bars
in the status bar of the
display indicate whether a connection exists.
15.2.1.2 Configuration via WPS function
This establishes a direct connection to the router. Selecting and/or entering a WLAN network (SSID) and password is not
required.
> Start the WPS function on your router in accordance with its operating instructions.
> Then select [PBC WLAN Setup] to start the connection process.
Please pay aention to the display. The connection process is usually completed aer a few seconds and the WLAN
connection can now be used.