TechniSat DIGITRADIO 451 CD IR

76
4.4.3 Source selection
> Press the MODE buon on the device (1) or on the remote control (14) multiple times to scroll through the available
sources.
The currently selected source is shown in the display.
4.4.4 Adjusting the volume
> Turn the VOLUME/ knob on the device (3) to decrease or increase the volume.
On the remote control, use the VOL+/- rocker buon (15).
The adjusted volume is shown in the display during the control process.
If the volume is turned down completely, the device switches to standby mode aer about 15 minutes.
4.4.5 Activating the mute function
> You can mute the volume using the audio mute buon (13). “Mute” appears in the display and in the status bar.
> Pressing the buon again switches the sound back on.
4.4.6 Menu operation
The menu is divided into the menu for the respective source and into the system seings that apply to all sources. Operation
within the menus is carried out using the SCROLL&SELECT knob (7) on the device or with the up/down arrow buons (10)
and the OK buon (9) on the remote control.
> Turn the SCROLL&SELECT knob (7) to the right and le or press the up/down arrow buons (10) on the remote control
to move the highlight or change the highlighted value.
> By turning the SCROLL&SELECT knob (7) or pressing the OK buon (9) on the remote control, you can confirm a
selection to enter a submenu or to save the set value.
If a value has been changed, this is saved. If there is an arrow (>) next to a menu item, you can access additional seings
or functions.