10.3
Setting the alarm time
You can only operate the alarm function once the correct time has been
set. Depending on the configuration, this happens automatically or must be
set manually.
The time can be updated either manually, via DAB or FM.
Further information on this can be found under point 11.1.
>
Use the < or > buttons to select one of the alarm time memories Alarm clock 1
or Alarm clock 2 and then press OK.
>
Then go through all the points in sequence. Confirm each entry with the OK
button. The system then automatically jumps to the next setting. You can
change the respective values or options
with < and >.
Time On > Set the time at which you are woken up
buttons < or > and OK to enter the desired setting.
To Next Page
Loading...
