Technogym RUN PERSONAL - Register Addr; Read from Low Kit; Register Value; Write to Low Kit

RUN PERSONAL: Service & maintenance manual - rev. 3.1
Page 9.4
9.2.2. REGISTER ADDR.
This button allows to select a specific parameter of the inverter, which then can be read using the
function described below: “Read from low kit”.
On the Display will appear a Numeric Keypad which allows to enter and/or modify the
numerical value of the parameter. Press CLEAR to delete the old value and insert the
new one, then press CONFIRM to save it.
The parameters are listed in tables at paragraph: 9.2.3. “Inverter parameters”.
9.2.2.1. Read from low kit
This button allows to read from Low Kit the value of the parameter set previously and displayed in
the display.
9.2.2.2. Register Value
This button allows to modify the value of the parameters. Press the button:
On the Display will appear a Numeric Keypad which allows to enter and/or modify the
numerical value of the parameter. Press CLEAR to delete the old value and insert the
new one, then press CONFIRM to save it.
The parameters are listed in the table of paragraph: 9.2.3. “Inverter parameters”.
After any changes to the parameter values, you need to save them in the low kit using
the “Write to low kit” function.
9.2.2.3. Write to low kit.
To write the values of the currently displayed parameters to the low kit, press the button:
Allows to write on the ALE inverter register, in case you have changed the data.