TECO A510-2001-H - (1) Over speed operation setting (20-19 to 20-21)

4-57
. when frequency reference is zero and operation command input, the motor will start to operate against
lower limit of frequency reference 00-13 and minimum value of minimum frequency 01-08( or 01-22).
. Please refer to Figure 4.3.6
Figure 4.3.6 Upper and lower limits of frequency reference
00-14 Acceleration time 1
Range
【0.1~6000.0】 Sec
00-15 Deceleration time 1
Range
【0.1~6000.0】 Sec
00-16 Acceleration time 2
Range
【0.1~6000.0】 Sec
00-17 Deceleration time 2
Range
【0.1~6000.0】 Sec
00-21 Acceleration time3
Range
【0.1~6000.0】 Sec
00-22 Deceleration time3
Range
【0.1~6000.0】 Sec
00-23 Acceleration time4
Range
【0.1~6000.0】 Sec
00-24 Deceleration time4
Range
【0.1~6000.0】 Sec
00-25 Switching frequency of acceleration and deceleration
Range
【0.00~400.00】Hz
【0.0~1200.0】Hz
( When 00-31 = 1)
Set each acceleration / deceleration time, acceleration time of default is set to 00-14, while the deceleration
time of default is set to 00-15.
. Accelerate the time: it is the required time from 0% to 100% of maximum output frequency (01-02) or
(01-16).
. Deceleration time: it is the required time from 0% to 100% of maximum output frequency (01-02) or
(01-16).