TECO A510-2001-H - Page 169

4-115
Table
4.3.12 Selection of analog output terminals function (04-11 and 04-16).
04-11,
04-16
Setting
Function
(Screen display)
Monitoring
paramters
12 Group
Remark
0 Output Freq 12-17
1 Freq Ref 12-16
2 Output Voltage 12-19
3 DC Voltage 12-20
4 Output Current 12-18
5 Output KW 12-21
6 Motor Speed 12-22
7 Output PF 12-23
8 AI1 Input 12-25
9 AI2 Input 12-26
10 Torque Ref 12-27
11 Current Iq 12-28
12 Current Id 12-29
13 Speed Deviation 12-30
14 Retain
15 ASR Output 12-32
16 Retain -
17 Voltage Ref Vq -
18 Voltage Ref Vd -
19 Retain -
20 Retain -
21 PID Input 12-36
22 PID Output 12-37
23 PID Setpoint 12-38
24 PID Feedback 12-39
25 Output Freq (SFS) -
26 PG Feedback 12-33
27
PG Compensation
volume
12-34
05-- Multi-Speed Group
05- 00
Acceleration and deceleration selection of multi-speed
Range
【0】:
Speed acceleration and deceleration time are set ty the acceleration and
deceleration time 1 ~ 4.
【1】:
Independent setting of speed set acceleration and deceleration time
05- 01
Frequency setting of speed-stage 0
Range
【
0.0~400.00】 Hz
【
0.0~1200.0】 Hz (when 00-31 = 1)
05-17
Acceleration time setting of multi speed 0
05-18
Deceleration time setting of multi speed 0
05-19
Acceleration time setting of multi speed1
05- 20 Deceleration time setting of multi speed 1
05- 21 Acceleration time setting of multi speed 2
05- 22 Deceleration time setting of multi speed 2
05- 23 Acceleration time setting of multi speed 3
05- 24 Deceleration time setting of multi speed 3
05- 25 Acceleration time setting of multi speed 4
05- 26 Deceleration time setting of multi speed 4
05- 27 Acceleration time setting of multi speed 5
05- 28 Deceleration time setting of multi speed 5
05- 29 Acceleration time setting of multi speed 6
05- 30 Deceleration time setting of multi speed 6
05- 31 Acceleration time setting of multi speed 7
05- 32 Deceleration time setting of multi speed 7