4-114
Figure 4.3.50 Analog output and related parameters
(1). Adjustment of analog output AO1 and AO2 (04-12, 04-13 and 04-17, 04-18).
. By using 04-12 to adjust AO1 and 04-17 to adjust AO2’s gain, 04-13 to adjust AO1
and 04-18 to adjust AO2’s bias, the output voltage or current or multi-function
analog output terminals AO1 and AO2 can be adjusted.
. Set the gain adjustment so that the output (10V) and the output of monitoring option
are corresponding by 100%.
. As to bias, the output characteristics with 10V will correspond to 100% of proportion
for offset.
. As to the analog output level adjustment, please refer to Figure 4.3.51.
Figure 4.3.51 Analog output level adjustment
(2). Selection of analog output terminals function (04-11 and 04-16).
.For the function options, please refer to the table 4.3.12.
To Next Page
Loading...
