TECO A510-2001-H - Page 272

4-218
3. Analog comparator
Symbol Description
c
Analog comparision mode (1~3)
d
Input comparision value selection (AS1~AS4,MD1~MD4,T1~T8,C1~C8,V1~V7)
e
Present analog input value
f
Set the reference comparision value (Upper limit)
(AS1~AS4,MD1~MD4,T1~T8,C1~C8,V1~V7, constant )
g
Set the reference comparision value (lower limit)
(AS1~AS4,MD1~MD4,T1~T8,C1~C8,V1~V7, constant )
h
Output point of the analog comparator (G1~G8)
The description of analog comparision mode：
(1) Analog comparision mode 1 (e ≤ g, h ON)
(2) Analog comparision mode 2 (e ≥ f, h ON)
(3) Analog comparision mode 3
(g ≤ e ≤ f, h ON)
Input comparision value selection (V1~V7)
(1) Input comparision value selection = V1: Set frequency
(2) Input comparision value selection = V2: Operation frequency
(3) Input comparision value selection = V3: AI1 input value
(4) Input comparision value selection = V4: AI2 input value
(5) Input comparision value selection = V5: keypad input value
(6) Input comparision value selection = V6: Operation current
(7) Input comparision value selection = V7: Torque value