4-219
4. Operation control command
Symbol Description
c
Forward /Reversal control can be set by ( I1~f8 )
OFF: Forward(FWD)
ON: Reversal(REV)
d
Speed terminal control can be set by ( I1~f8 )
OFF: Operation based on e set frequency
ON: Operation based on frequency of speed f
e
Set frequency (can be constant or V3、V4，V5 )
f
Speed frequency (can be constant or V3、V4，V5)
g
Acceleration time (ACC Time)
h
Deceleration time (DEC Time)
i
Operation control command number (FROM F1 TO F8, THERE ARE 8 GROUPS IN
TOTAL.)
Example:
Input from LADDER program
Input from function program
When inverter starts running, F1=ON, and at the same
time, the F1 input of LADDER program is ON too.
RUN/STOP of F1 is determined by ON/OFF of I1
To Next Page
Loading...
