4-4
Indicating light of
operation command
by external control
Lighted on when the
operation command is
set to external control.
Indicating light of
frequency command
by external control
Lighted on when the
frequency command is
set to external control.
Indicating light of
operation
Lighted on under
operation status
It will flash in idle
status.
Indicating light of stop
Lighted on under stop
status
It will flash in DC
braking process.
4.1.3 Functional structure of LED seven-segment display
Basic displays are shown as below:
DSP/FUN
DSP/FUN
Dispays set by users are as below:
12- 00
Display selection
Range
0
0 0 0 0
Highest bit Lowest bit
The setting range for each bit is 0~7 from the highest bit to the lowest bit.
【0】: No display 【1】: Output current
【2】: Output voltage
【3】: DC voltage
【4】: Temperature 【5】: PID feedback
【6】: AI1 value 【7】: AI2 value
The highest bit of 12- 00 presents the default boot screen, while the other bits present the display
screen set by users.
Example 1: set 12- 00=【10000】
Display of power on:
voltage of power
Inverter’s output current
Set Frequency
Parameter selection
After 3
seconds
Voltage of the power on
Frequency
Mode
switching
Parameter selection
After 3
seconds
To Next Page
Loading...
