TECO A510-2001-H - Page 68

4-15
stop)
16 : PID control disable
17: Fault reset (RESET)
18: Retain
19: Speed Search 1(from the
maximum frequency)
20: Manual energy saving
function
21: PID integral reset
22 : Retain
23 : Retain
24: PLC input
25: External fault
26:
3-Wire sequence
(Forward/Reverse command).
27: Local/Remote selection
28: Remote mode selection
29: Jog frequency selection
30: Acceleration/deceleration
setting command 2
31: Inverter overheating
warning
32: Sync command
33: DC braking
34: Speed Search 2 (from the
frequency command)
35: Timing function input
36: PID Soft start invalid
37: Traversing operation
38 : Upper Deviation of
traverse operation
39 : Lower Deviation of
traverse operation
40: Switching between motor
1/motor 2
41: Retain
42: PG invalid
43: PG integral reset
44: Mode switching between
speed and torque
45: Negative torque command
46 : Zero-Servo Command
47: Fire Mode
48: KEB acceleration
49:Parameters writing
allowable
50 : Unattended Start
Protection (USP)
51: Mode switching between
speed and position