TECO A510-2001-H - Page 70

4-17
missing
27: Timing function output
28:
Traverse operation UP
Status
29 : During Traverse operation
status
30 : Motor 2 Selection
31 : Zero Servo Completed
32: Communication control
contacts
03-13
Frequency detection
Level
0.0~400.0
0.0~1200.0 (when 00-31 = 1)
0.0 Hz O O O O O O
03-14
Frequency detection
width
0.1~25.5 2.0 Hz O O O O O O
03-15 Retain
03-16 Retain
03-17 Retain
03-18 Retain
xxx0b: R1 A contact xxx1b: R1
B contact
03-19 Relay (R1A-R2C) type
xx0xb: R2 A contact xx1xb: R2
B contact
0000b - O O O O O O
03-20 Retain
03-21 Retain
03-22 Retain
03-23 Retain
03-24 Retain
03-25 Retain
03-26
Retain
0: maintain UP/DOWN
frequency when stopping
1: clear UP/DOWN frequency
when stopping
03-27
UP/DOWN frequency
maintaining selection
2: allow UP/DOWN frequency
when stopping
0 - O O O O O O
03-28 Optocoupler output
Range and definition are the
same as those of 03-11,
03-12
0 - O O O O O O
03-29
optocoupler output
selection
xxx0b: optocoupler A contact
xxx1b: optocoupler B contact
0000b - O O O O O O
0: Frequency command
1: PID feedback
2: PID target value
03-30
Function setting of
pulse input
3: Retain
0 - O O O O O O
03-31 Scale of pulse input 50~32000 1000 Hz O O O O O O *1
03-32 Gain of pulse input 0.0~1000.0 100 % O O O O O O *1
03-33
Bias voltage of pulse
input
-100.0~100.0 0.0 % O O O O O O *1
03-34 Filter time of pulse input0.00~2.00 0.1 Sec O O O O O O *1