TECO A510-2001-H - ■ Write: Use the following steps to write in the parameter settings of the operation interface of digital operator to the inverter.

4-43
Group 15 PLC Monitoring Group
Control mode
Code Parameter Name Range Default Unit
V/F
V/F
+PG
SLV SV
PM
SV
PM
SLV
Attrib
ute
15-30 MD3 current value 0~65535 0 - O O O O O O
15-31 MD4 current value 0~65535 0 - O O O O O O
15-32 TD current value 0~65535 0 - O O O O O O
Group 16 LCM Function Group
Control mode
Code Parameter Name Range Default Unit
V/F
V/F
+PG
SLV SV
PM
SV
PM
SLV
Attrib
ute
16-00
Main screen
monitoring
5~64
when using LCM to operate,
the monitored item displays in
the first line. (default is
frequency command)
16 - O O O O O O *1
16-01
Sub-screen monitoring
1
5~64
when using LCM to operate,
the monitored item displays in
the second line. (default is
output frequency)
17 - O O O O O O *1
16-02
Sub-screen monitoring
2
5~64
when using LCM to operate,
the monitored item displays in
the third line. (default is output
current)
18 - O O O O O O *1
0~39999
determine the display way and
unit of frequency command
0: Frequency display unit is
0.01Hz
1: Frequency display unit
0.01%
2~38: rpm, the set number
represents the pole number of
motor
40~9999:
Users specify the format,
Inputing 0XXXX represents
the display of XXXX at 100%.
10001~19999:
Users specify the format,
Inputing 1XXXX represents
the display of XXX.X at 100%.
20001~29999:
Users specify the format,
Inputing 1XXXX represents
the display of XX.XX at 100%.
16-03 Display unit
30001~39999:
0 - O O O O O O