TECO L510 - Motor and Application Specific Settings; Set Motor Nameplate Data (02-01)

8-1
8. Motor and Application Specific Settings
It is essential that before running the motor, the motor nameplate data matches the motor data in the inverter.
8.1 Set Motor Nameplate Data (02-01)
02-01 Motor Rated Current (OL1)
The motor rated current is set at the factory based on the inverter model. Enter the motor rated current from the
motor nameplate if it does not match the value shown in parameter 02-01.
Setting range: Varies by model.
To set parameter 02-01:
- After power-up press the MODE key
- Select 02-01 using the arrow keys and up/down keys
- Press </ENTER key
- Set parameter 02-01 using the arrow keys and </ENTER key to save setting.