Fire Hazard
Tighten all terminal screws to the specified tightening torque.
Loose electrical connections could result in death or serious injury by fire due to overheating of electrical
connections.
Do not use an improper voltage source.
Failure to comply could result in death or serious injury by fire.
Verify that the rated voltage of the inverter matches the voltage of the incoming power supply before applying
power.
Do not use improper combustible materials.
Failure to comply could result in death or serious injury by fire. Attach the inverter to metal or other
noncombustible material.
Observe proper electrostatic discharge procedures (ESD) when handling the inverter and circuit
boards.
Failure to comply may result in ESD damage to the inverter circuitry.
Never connect or disconnect the motor from the inverter while the inverter is outputting voltage.
Improper equipment sequencing could result in damage to the inverter.
Do not use unshielded cable for control wiring.
Failure to comply may cause electrical interference resulting in poor system performance. Use shielded
twisted-pair wires and ground the shield to the ground terminal of the inverter.
Do not modify the inverter circuitry.
Failure to comply could result in damage to the inverter and will void warranty. TECO is not responsible for any
modification of the product made by the user. This product must not be modified.
Check all the wiring to ensure that all connections are correct after installing the inverter and
connecting any other devices.
Failure to comply could result in damage to the inverter.
To Next Page
Loading...
