TECO L510 - Page 39

4-5
4.1.4 Power-Up Monitor
Power Up:
MODE
MODE
After 2 sec.
Display at Power-up Frequency Reference Parameter Selection
Change Monitor at Power-Up
12-00
Display selection
Range
Highest bit -> 0 0 0 0 0 <- Lowest bit
The setting range for each bit is 0 ~ 7 from the highest bit to the lowest bit.
0: No display 4: Temperature
1: Output current 5: PID feedback
2: Output voltage 6: AVI value
3: DC voltage 7: ACI value
Example: 12-00 = 10000
MODE
MODE
After 2 sec.
Parameter Selection
Output Current
Frequency Reference
Display Voltage Class
at Power-up
MODE