TECO S310+ Series User Manual

4-44
Group11-keypad display group
11- 00 Display Mode
Range
xxxx0：Disable Motor Current Display
xxxx1：Enable Motor Current Display
xxx0x：Disable Motor Voltage Display
xxx1x：Enable Motor Voltage Display
xx0xx：Disable Bus Voltage Display
xx1xx：Enable Bus Voltage Display
x0xxx：Disable temperature Display
x1xxx：Enable temperature Display
11- 01
Custom Units (Line Speed) Value
Range
【0~65535】Rpm
The max preset line value of 11-01 is equal to the rated frequency (06-04) of the motor. For instance,
given line speed 1800 is equal to display 900 when output is 30Hz while the operation frequency is
60Hz.
11- 02 Custom Units (Line Speed) Display Mode
Range
【0】：Drive Output Frequency is Displayed
【1】：Line Speed is Displayed in Integer (xxxxx)
【2】：Line Speed is Displayed with One Decimal Place (xxxx.x)
【3】：Line Speed is Displayed with Two Decimal Places (xxx.xx)
【4】：Line Speed is Displayed with Three Decimal Places (xx.xxx)
When 11-02=1/2/3/4，line speed is displayed while the inverter is running or stopped.
11-08 Keypad frequency flashing when stop
Range
【0】：Enable
【1】：Disable
Group12- User parameter group
12- 00 Drive Horsepower Code
Range ----
12-00
Inverter Model
401
S310+
401
402 402
403 403
405 405
12- 01
Software Version
Range
----
Note:Read only
12- 02
Fault Log（Latest 3 times）
Range ----
1) When the inverter trips on a fault, the previous fault log stored in2.xxx will be transferred to 3.xxx,
the one in 1.xxx to 2.xxx. The present fault will be stored in the empty register 1.xxx. The fault stored
in 3.xxx is the last one of the most recent three, while the one 1.xxx is the latest.
2) When pressing ‘ENTER’ at 12-02, the fault 1.xxx will be displayed first. Press▲, to read
2.xxx→3.xxx→1.xxx press▼ and the order is 3.xxx→2.xxx→1.xxx→3.xxx.

TECO S310+ Series Specifications

General

Brand	TECO
Model	S310+ Series
Category	Controller
Language	English