TECO SPEECON 7200GS - Parameter Description

22
2.3 Parameter description
The 7200GS/GS510 has 4 groups of user parameters:
Parameters
*4
Description
An-□□
Frequency command
Bn-□□
Parameter settings can be changed during running
Sn-□□
System parameter settings (can be changes only after stop)
Cn-□□
Control parameter settings (can be changed only after stop)
The parameter setting of Sn-03 (operation status) will determine if the setting value of
different parameter groups are allowed to be changed or only to be monitored, as shown
below:
Sn-03
DRIVE mode PRGM mode
To be set To be monitored To be set To be monitored
0000
*1
An, Bn Sn, Cn An, Bn, Sn, Cn
－
0101
*2
An Bn, Sn, Cn An Bn, Sn, Cn
*1：Factory setting
*2：When in DRIVE mode, the parameter group Sn-, Cn- can only be monitored if the
RESET
key and the
DSPL
key are to be pressed at the same time,
*3： After a few trial operation and adjustment, the setting value Sn-03 is set to be
“0101" so as not be modified again.
*4：The 7200GS/GS510 has 2 groups of monitoring parameters and one group of order
parameters in addition to the above 4 groups of user parameters.
Un-□□：Can be monitored by the users under the DRIVE mode.
Hn-□□：Can be monitored by the users under the PRGM mode.
*5：On-□□：Order parameters can be monitored and changed by setting Sn-03=1010.