TECO SPEECON 7200GS - Description of Using 7200 Gs;Gs510; Using LCD (or LED) Digital Operator

19
2. DESCRIPTION OF USING 7200GS/GS510
2.1 Using LCD (or LED) digital operator
 7200GS/GS510 are standard with LCD digital operator JNEP-32. Moreover, an LED digital
operator JNEP-33 is also available. Three two digital operator have the same operation
functions except the LCD and 7-segments LED display difference.
 The LCD and LED digital operator has 2 modes: DRIVE mode and PRGM mode. When the
inverter is stopped, DRIVE mode or PRGM mode can be selected by pressing the
key
PRGM
DRIVE
. In DRIVE mode, the operation is enabled. Instead, in the PRGM mode, the
parameter settings for operation can be changed but the operation is not enabled.
a. The LCD digital operator component names and functions shown as below:
RUN STOP
PRGM
DRIVE
DSPL
EDIT
ENTER
DIGITAL OPERATOR JNEP-31
DRIVE FWD REV REMOTE
SEQ
REF
FWD
REV
JOG
RESET
operation mode indicators
DRIVE : lit when in DRIVE mode
FWD : lit when there is a forward run command input
REV : lit when there is a reverse run command input
SEQ
: lit when the run command is enabled from the control circuit
terminal or RS-485 option card (REMOTE mode)
REF : lit when the frequency reference from the control circuit
terminals (VIN or AIN) or RS-485 option card enabled
(REMOTE mode)
LCD Display
Chinese Display: 2 row, each row has 8 characters at most
English Display: 2 row, each row has 20 characters at most
Keys (Key functions are defined in Table 11)
Fig 9-a LCD Digital operator component names and functions
b. The LED digital operator component names and functions shown as below:
RUN STOP
PRGM
DRIVE
DSPL
EDIT
ENTER
DIGITAL OPERATOR JNEP-31
DRIVE FWD REV REMOTE
SEQ
REF
FWD
REV
JOG
RESET
operation mode indicators
DRIVE : lit when in DRIVE mode
FWD : lit when there is a forward run command input
REV : lit when there is a reverse run command input
SEQ
: lit when the run command is enabled from the control circuit
terminal or RS-485 option card (REMOTE mode)
REF : lit when the frequency reference from the control circuit
terminals (VIN or AIN) or RS-485 option card enabled
(REMOTE mode)
LED Display
5 digitals 7-degment LED.
Keys (Key functions are defined in Table 11)
32
32
33
JOG
(L/R)
JOG
(L/R)