TECO SPEECON 7200GS - DRIVE Mode and PRGM Mode Displayed Contents

21
2.2 DRIVE mode and PRGM mode displayed contents
*1：When the inverter is put into operation,
the inverter system immediately enters into
DRIVE mode. Press the
PRGM
DRIVE
key,
the system will switch into PRGM mode.
*2：If no fault occurred before power supply
was turned off , display the monitored data
according to the Bn-10 setting
*3：When in the DRIVE mode,
press the
DSPL
key and
RESET
key, the setting values of Sn- and Cn-□□ will only be
displayed for monitoring but not for changing or setting.
Power on
DRIVE mode
PRGM
DRIVE
*1
PRGM mode
DSPL
DSPL
Bn-□□ monitor／set
DSPL
Sn-□□ monitor／set
DSPL
Cn-□□ monitor／set
DSPL
Hn
-
□□
monitor
／
set
An
-
□□
monitor
／
set
DSPL
Frequency reference
DSPL
Un
-
□□
monitor
DSPL
An
-
□□
monitor
／
set
Bn-□□ monitor／set
DSPL
Sn-□□ monitor
DSPL
DSPL
*3
＋
RESET
DSPL
Output Frequency
Output Current
PID detected value
*2