40
3.6 Monitoring Parameters H n - □ □
□ □□ □
□ □
The inverter input/output interface status can be monitored under the PRGM mode by Hn-□
□ parameter.
Hn-□□ parameter will toggle display with low voltage protection alarm (UV) if the UV
alarm occurred.
Parameter
No.
Name
LCD Display
(English)
Unit Descriptions
Hn-01 Main Circuit DC Voltage
Hn-01=622.0V
DC Voltage
0.1V
Display DC voltage of inverter main circuit
Hn-02 Input Terminal Status
Hn-02=00000000
I/P Term. Status
－
0
0
0
0
0
0
0
0
0：OPEN
1：CLOSE
Input terminal ○
1
Input terminal ○
2
Input terminal ○
3
Input terminal ○
4
Input terminal ○
5
Input terminal ○
6
Input terminal ○
7
Input terminal ○
8
Hn-03 Output Terminal Status
Hn-03=00000000
O/P Term. Status
－
0
0
0
0
0
0
0
0
0：OPEN
1：CLOSE
Relay Contact R2A-
R2C
Opto-contact D01-
DCOM
Opto-contact R1A-
R1C
Reversed
Reversed
Reversed
Reversed
Reversed
Hn-04 Option card code
Hn-04=0
None Opt. Card
1
0：None of option card is installed
1：PA-M, PA-L, PA-C card is installed.
2~5：Reserved
6：PA-P, PA-L, PA-C card is installed .
7：Reserved
8：PA-PID card is installed.
Hn-05
U phase current (IU)
conversion value
Hn-05=2.50V
IU current
0.01V
Range：0.00V ~ 5.00V
Hn-05, Hn-06 can be used to check DCCT
function.
Hn-07, Hn-08 can be used to check ADC
function in the control board.
Troubleshooting used.
Hn-06
W phase current (IW)
conversion value
Hn-06=2.50V
IW current
Hn-07
3 phase rectify current
(DIAC) conversion value
Hn-07=1.00V
DIAC current
Hn-08
ADC Reference Volt.
conversion value
Hn-08=2.50V
ADCHK Voltage
To Next Page
Loading...
