EasyManua.ls Logo

Tecsun PL-990x - Enabling;Disabling Longwave (LW); Settings When Using Internal;External Antennas

Tecsun PL-990x
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
Display indicates “ ”:
MW tuning steps are set to 10 kHz.
MW frequency range is 520 ~ 1710 kHz (for North and South America).
LW frequency range is 100 ~ 519 kHz.
SW frequency range is 1711 ~ 29999 kHz.
Enabling/Disabling Longwave (LW)
With the device off, press and hold the [ 2 ] (LW ON/OFF) button, the display
shows “ ” (enabled) or “ ” (disabled). To select the LW frequency band,
power on the device and then quick press the [ MW/LW ] button twice.
Settings When Using Internal/External Antennas
When using the telescopic whip antenna, push the antenna selector switch
[ ANT. SWITCH ] to “INT.”. When an external antenna is connected to the
[ ANTENNA ] socket, set the selector switch to “EXT.”.
Caution! When using an outdoor antenna, waterproofing and lightning
protection measures must be taken.

Table of Contents

Related product manuals