Tecsun PL-990x User Manual

DELETING STORED STATIONS
Deleting a Single Station
1) Enter the memory (VM) mode and select the
station that you wish to delete.
2) Press and hold the [ ] (DELETE) button
until “dEL” and “PRESET” flash on the display.
3) Quick press the [ ] button to delete
the unwanted station.
Deleting Stations During Memory Page Scan
This device can auto scan all stored stations within a memory page, staying on
each station for about 5 seconds, and giving you the opportunity to delete any
unwanted stations.
1) Select the memory page from which you wish to delete stored stations
(see also page 15 on recalling stored stations).
2) Press and hold the [ VF/VM ] button to start the memory scan.
3) Upon finding an unwanted station, press the [ ] (DELETE) button. No
confirmation is required and scanning continues immediately.
4) To stop the memory scan, gently rotate the [ TUNING ] knob.
Deleting All Stored Stations
To delete all stations within a memory page:
1) Select the memory page from which you wish to
delete all stored stations.
2) Press and hold the [ ] (DELETE) button until
“dEL” and “PAGE” flash on the display.
3) Quick press the [ ] button again to confirm.
Note: In Page 0, stored stations need to be deleted for each frequency band or
mode (SYNC/SSB) separately.
PAGE PRESET
16
PAGE PRESET

Tecsun PL-990x Specifications

General

Frequency Range AM	520 - 1710 kHz
Frequency Range SW	1711 - 29999 kHz
Frequency Range LW	100 - 519 kHz
Display	LCD with backlight
SSB	Yes
Selectivity FM	>60dB
Frequency Range FM	64-108 MHz
Type	Portable Radio
Modes	AM, FM, LW, SW, SSB
Audio Output	Headphone and speaker
Antenna	External antenna jack, telescopic antenna
Tuning Steps AM	1 kHz / 9 kHz / 10 kHz
Tuning Steps SW	1 kHz / 5 kHz
Sensitivity FM	3 μV
Sensitivity AM	1 mV/m
Selectivity AM	>60dB
Additional Features	Alarm clock, Sleep timer