15
LISTENING TO STORED STATIONS
When recalling stored stations or initiating a memory page scan, Page 0 (P0)
only shows the stations of the frequency band (FM/LW/MW/SW) or mode
(SYNC/SSB) that was selected before entering the memory (VM) mode. In
Pages 1-24 it is not necessary to preselect a frequency band, the device will
show stored stations from all bands within the selected memory page.
Recalling Stored Stations
Operation for memory Page 0:
1) Use the [ PAGE - ] or [ PAGE + ] button to select memory page P0.
2) Select a frequency band (FM, LW, MW, SW) or mode (SYNC, SSB).
3) Quick press the [ VF/VM ] button to enter the VM mode (see also page 9).
4) Rotate the [ TUNING ] knob with some vigor to browse through the station
list, or use the numeric keys to directly enter the preset station number.
Operation for memory Page 1-24:
1) Use the [ PAGE - ] or [ PAGE + ] button to select a memory page.
2) Rotate the [ TUNING ] knob with some vigor to browse through the selected
memory page, or use the numeric keys to directly enter the preset station
number.
Memory Page Scan
This device can auto scan all stored stations within a memory page, staying on
each station for about 5 seconds.
1) Use the [ PAGE - ] or [ PAGE + ] button to select a memory page.
2) Press and hold the [ VF/VM ] button until “PRESET” flashes in the upper
right corner of the display. The device starts to scan all stored stations within
the selected memory page.
3) To stop scanning, quick press the [ VF/VM ] button or gently rotate the
[ TUNING ] knob.
To Next Page
Loading...
Need help?
General
