19 115-0917-010
Function Keys
The NOVA DVR keypad interface allows instance access to the user’s favorite 10 preset speeds.
Set speed to “Preset speed #1”
Set speed to “Preset speed #2D”
Set speed to “Preset speed #3”
Set speed to “Preset speed #4”
Set speed to “Preset speed #5”
Hold “Mode” + F1
or Double press F1
Set speed to “Preset speed #6”
Hold “Mode” + F2
or Double press F2
Set speed to “Preset speed #7”
Hold “Mode” + F3
or Double press F3
Set speed to “Preset speed #8”
Hold “Mode” + F4
or Double press F4
Set speed to “Preset speed #9”
Hold “Mode” + F5
or Double press F5
Set speed to “Preset speed #10”
Speed Dial Knob
The speed dial allows the user to control the speed and navigate the menu system on the HMI.
Increase Speed – Fine Adjustment
(Menu: Scroll Down)
Decrease Speed – Fine Adjustment
(Menu: Scroll Up)
Press and Hold
&
Turn Clockwise
Increase Speed – Coarse Adjustment
Press and Hold
&
Turn Counter Clockwise
Decrease Speed – Coarse Adjustment
The speed dial has 2 modes when adjusting the spindle speed; fine adjustment mode and coarse adjustment mode. Fine adjustment mode
increases/ decreases the desired speed value in small step sizes. Coarse adjustment mode increases/ decreases the desired speed value
in greater step sizes, allowing the user to quickly adjust the speed. A small step adjustment at low speed will allow the user to accurately
control the speed, while a larger step size at a higher speed will allow the user to adjust the speed quickly. The table below lists the step
sizes for the fine and coarse speed adjustment for the speed ranges.
To Next Page
Loading...
