Faceplates:
SFP80L (with side-locking function).
Faceplates are used to mount the work piece when
faceplate turning bowls or platters. Faceplates are
available in 80mm (3") diameter. A vacuum faceplate is
also available. The 80mm (3") faceplate is made of solid
steel. This faceplate has a small contact area to allow
maximum freedom while shaping. It comes with 2 notches
on the outside diameter for removing the faceplate from
the spindle. This can be done with a light drift and mallet.
Outrigger Unit: 55223
Extend the bowl turning capacity of the Nova DVR
SATURN Woodlathe to up to 740mm (29in.) in diameter.
This unit is made from cast iron, is easy to position and
control, and mounts to the headstock end of the lathe.
G3 Chuck
NOVA G3 Wood Turning Chuck Insert Type is
a 4 Jaw self-centering geared chuck. With
unique NOVA features such as Auto Stop,
Copper composite Jaw Slides, Woodworm
Screw, Comfortable T Bar Handle and 2″
Jaws as standard, this chuck is fully featured.
Powerful Tuff Lock gearing with precise,
hardened action delivers incredibly smooth
strength for a solid, vibration free
performance. Takes the same accessory
range as other NOVA Chucks.
Supernova 2 Chuck
Designed for the tough demands of
modern woodturning. Body is precision
machined from high quality K1045
machine steel. Gearing is heavy section,
hardened steel to provide a powerful
action. The greater holding strength,
stability, and precision decreases
vibration from small delicate turnings right
up to large bowls and platters work (up to
29”/740mm)
To Next Page
Loading...
