1-5
REV DEC 1986
·Performance Requirement not checked in the manual.
Characteristics
Performance Requirements
Input R (50
Q)
Resistance
50
Q
±1%.a
VSWR (DC to 150 MHz)
1.3:1 or better.a
Maximum Input Voltage
A
5 V rms; 0.5 W·sec for anyone-second interval for instantaneous
voltages from 5 V to 50 V.
Maximum Input Voltages
A
Input Coupling Set to DC, AC, or GND
400 V (dc + peak ac); 800 V popac at 10 kHz or less.a
Common-Mode Rejection Ratio (CMRR);
At least 10:1 at 50 MHz for common-mode signals of 10 divisions
ADD Mode with Either Channel Inverted
or less with VARIABLE VOLTS/DIV adjusted for best CMRR at
50 kHz.
POSITION
Range ±(9.6 to 10.7) divisions ±0.4, ±0.7 div. At 50 mV per division
with INVERT off, when Self Cal has been done within ±5°C of
the operating temperature.
Gain Match Between NORMAL and SAVE
± 3 DLs for positions within ± 5 divisions from center.
Low-Frequency Linearity
Normal or Average Mode
3 DLs or less compression or expansion of a two-division,
center-screen signal when positioned anywhere within the
acquisition window.
20 MHz Bandwidth Limiter
- 3 dB Bandwidth 13 MHz to 24 MHz.
50 MHz Bandwidth Limiter
-3 dB Bandwidth 40 MHz to 55 MHz.
Rise Time
6.3 ns to 8.7 ns.a
With a five-division, fast-rise step (rise time of 300 ps or less)
using 50
Q
dc input coupling and VOLTS/DIV setting of 10 mV.a
Table 1-1 (cont)
Specification-2430 Service
To Next Page
Loading...
