Tektronix 2430 - Page 18

1-8
aperformanceRequirementnot checked in the manual.
Characteristics Performance Requirements
Variable A Trigger Holdoff A SEC/Diva
MIN Hoa
MAX Hoa
5 ns 2-4 f,lS
10 ns
20 ns 9-15 f,lS
50 ns
100 ns
200 ns
500 ns
5-10 f,lS
1 f,lS
10-20 us
2 f,lS
20-40 f,lS 100-150 f,lS
5 f,lS
50-100 f,lS
10 f,lS
0.1-0.2 ms
20 f,lS 0.2-0.4 ms
1-1.5ms
50 f,lS 0.5-1.0 ms
100 f,lS 1-2 ms
200 f,lS 2-4 ms
10-15 ms
500 us 5-10 ms
1 ms
10-20 ms
2 ms
20-40 ms
90-150 ms
5 ms 50-100 ms
10 ms 0.1-0.2 s
20 ms 0.2-0.4 s 0.9-1.5 s
50 ms 0.5-1.0 s
100 ms 1-2 s
200 ms 2-4 s
500 ms
9-15 s
1 s
2s 5-10 s
5s
SLOPE Selection Conforms to trigger-source
waveform and ac-power-source
waveform.
Trigger Position Jitter (p-p)
SEC/DIV 0.5 f,lS per Division or Greater
A and B Triggered Sweeps
0.04 X SEC/DIV setting.a
B RUNS AFTER Delay 0.08 X SEC/DIV settinq."
SEC/DIV 0.2 f,lS per Division or Less (0.02 X SEC/DIV setting) + 2 ns."
Checked at 5 ns/div with Repet OFF using a six-division, 10 MHz
sine-wave input.a
Table 1-1 (cont)
Specification-2430 Service