Commands Listed in Alphabetical Order
Syntax
CURSor:VBArs:
DELTa?
Returns
NR3
Examples
CURSOR:VBARS:DELTA? might return CURSOR:VBARS:DELTA
1.65330661323E-009
, indicating the delta between the vertical bar cursors
in absolute horizontal units.
CURSor:VBArs:POSition<x>
This command sets o r queries the position of the specified vertical bar cursor,
which is constrained to be within the displayed range. The cursor is specified by
x, which can be 1 or 2. (Use the CURSor FUNCtion command to set the cursor
function to vertical bars.) This is equivalent to entering a value in the Cursor 1 or
Cursor 2 Position control in the Cursor Setup dialog box.
Group
Cursor
Syntax
CURSor:VBArs:POSition<x> <NR3>
CURSor:VBArs:POSition<x>?
Related Commands
HORizontal:MAIn:TOFPoint?, HORizontal:MAGnify<x>:TO FPoint?,
HORizontal:MATH<x>:MAIn:TOFPoint?, HORizontal:MATH<x>:
MAGnify<x>:TOFPoint?, HORizontal:REF<x>:MAIn:TOFPoint?,
HORizontal:REF<x>:MAGnify<x>:TOFPoint?
Arguments
NR3 specifies the cursor position measured from the trigger point of th
esource
waveform.
Examples
CURSOR:VBARS:POSITION2 9.0E-6 positions the cursor 2 vertical bar cursor
at 9 µs from the trigger point of the source waveform.
CURSOR:VBARS:POSITION1? might return CUR SOR:VBARS:POSITION1
17.4929859719E-009
, indicating that the cursor 1 vertical bar is at 17.49 ns
from the trigger point of the source waveform.
CURSor:WAVeform? (Query Only)
This query only command returns all of the waveform cursor parameters.
DSA/CSA/TDS8X00/B Series Programmer Manual 2-105
To Next Page
Loading...
