Commands Listed in Alphabetical Order
Group
RF
Syntax
RF:RF_AVErage:NUMAVg <NR1>
RF:RF_AVErage:NUMAVg?
Related Commands
RF:RF_AVErage:COUNt?
Arguments
<NR1> is an integer.
Examples
RF:RF_AVErage:NUMAVg 100 sets the number of acquisitions to be used for the
RF average trace to 128 (the closest power of 2 increment).
RF:RF_AVErage:NUMAVg? might return 16, indicating that the number of
averages for the RF average trace has been set to 16.
RF:RF_FREQuency:LABel
This command specifies the label for the RF Frequency vs. Time trace.
Conditions
MDO4000/B/C models only.
Group
RF
Syntax
RF:RF_FREQuency:LABel <QString>
RF:RF_FREQuency:LABel?
Related Commands
RF:RF_AMPlitude:LABel, RF:RF_PHASe:LABel, RF:LABel
Arguments
<QString> is a quoted string of up to 32 characters.
RF:RF_FREQuency:VERTical:POSition
This command specifies the vertical position for the RF Frequency vs. Time trace.
The position value determines the vertical graticule location at which thetrace
is displayed. Increasing the position value of a waveform causes the waveform
to move up. Decreasing the position value causes the waveform to move down.
The minimum is -50 divisions and the maximum is 50 divisions with a resolution
of 0.02 divisions.
2-576 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
