Commands Listed in Alphabetical Order
RF:RF_FREQuen
cy:VERTical:SCAle?
might return 1.0000E+6, indicating
that the vertical scale has been set to 1 MHz/division.
RF:RF_PHASe:LABel
This command specifies the label for the RF Phase vs. Time trace.
Conditions
MDO4000/B/C models only.
Group
RF
Syntax
RF:RF_PHASe:LABel <QString>
RF:RF_PHASe:LABel?
Related Commands
RF:RF_AMPlitude:LABel, RF:RF_FREQuency:LABel, RF:LABel
Arguments
<QString> is a quoted string of up to 32 characters.
RF:RF_PHASe:REFERence:DEGrees
This command sets or returns the phase, in degrees, at the trigger point for the
RF_PHASe time domain trace. The value can range from –180 to +180 degrees.
The default is 0.0 degrees and the resolution is 1.0 degrees.
Conditions
MDO3000, MDO4000/B, or MDO4000C models with option SA3 or SA6 only.
Group
RF
Syntax
RF:RF_PHASe:REFERence:DEGre
es?
RF:RF_PHASe:REFERence:DEGrees <NR3>
RF:RF_PHASe:VERTical:POSition
This command specifies the vertical position for RF Phase vs. Time trace. The
position value determines the vertical graticule location at which the trace is
displayed. Increasing the position value of a waveform causes the waveformto
move up. Decreasing the position value causes the waveform to move down. The
minimum is -50 divisions and the maximum is 50 divisions with a resolution
of 0.02 divisions.
2-578 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
