Commands Listed in Alphabetical Order
Arguments
NORMal specifie
s the normal frame type.
PAYLoad specifies the payload frame type.
NULL specifies the null frame type.
SYNC specifies the sync frame type.
STARTup specifies the startup frame type.
Examples
TRIGGER:A:BUS:B1:FLEXRAY:FRAMETYPE PAYLOAD sets the frame type to
payload.
TRIGGER:A:BUS:B1:FLEXRAY:FRAMETYPE? might return
TRIGGER:A:BUS:B1:FLEXRAY:FRAMETYPE NORMAL indicating the
frame type is set to normal.
TRIGger:A:BUS:B<x>:FLEXray:HEADER:CRC
This command specifies the CRC portion of the binary header string when
triggering on the FlexRay bus signal. The trigger condition needs to be set to
HEADer (using TRIGger:A:BUS:B<x>:FLEXray:CONDition).
B<x>
Conditions
This command requires a DPO4AUTOMAX application module for
DPO/MSO4000B and MDO4000/B/C models or MDO3FLEX application module
for MDO3000 models.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:FLEXray:HEADER:CRC <QString>
TRIGger:A:BUS:B<x>:FLEXray:HEADER:CRC?
Arguments
<QString> is a quoted string that is the CRC portion of the binary header string.
Examples
TRIGGER:A:BUS:B1:FLEXRAY:HEADER:CRC “11001100101” sets the CRC
portion of the binary header string to 11001100101.
TRIGGER:A:BUS:B1:FLEXRAY:HEADER:CRC? might return
TRIGGER:A:BUS:B1:FLEXRAY:HEADER:CRC "XXXXXXXXXXX" indicating the
CRC portion of the binary header string is don't care.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-819
To Next Page
Loading...
Need help?
General
