Command Descriptions
2- 122
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
HARDCopy:LAYout { LANdscape | PORTRait }
HARDCopy:LAYout?
LANdscape specifies that the bottom of the hard copy is along the
long side of the piece of paper.
PORTRait specifies that the bottom of the hard copy is along the
short side of the piece of paper. This is the standard format.
HARDCopy:LAYout?
Might return PORTRAIT as the page layout format of the hard c opy
output.
HARDCopy:PORT
Selects where to send the hard copy data when the oscilloscope
receives the next HARDCOPY STARt command. This command is
equivalent to setting the Port option in the UTILITY > Options >
Hard Copy Setup menu.
NOTE. The TDS1000B and TDS2000B oscilloscopes provide
PictBridge printer support through a USB Device port on the rear of
the oscilloscope. See the PictBridge commands on page 2--27.
Hard copy
HARDCopy:PORT { CENtronics | RS232 | GPIb | USB }
HARDCopy:PORT?
Syntax
Arguments
Examples
Group
Syntax
To Next Page
Loading...
