Command Descriptions
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
2- 129
HARmonics:SELect <NR1>
HARmonics:SELect?
<NR1> specifies the harmonic from 1 to 50.
HARmonics:SELect 1
Instructs the oscilloscope to select the first harmonic.
HARmonics:SELect?
Might return 3, indicating that the third ha rmonic is selected.
HARmonics:SHOW
HARmonics:SETUp
(TPS2000 Series with TPS2PWR1 Power Analysis Module Only)
Sets or queries the ope rating mode of harmonics measurements.
Power Measurement
HARmonics:SETUp { MANUAL | AUTOMATIC }
HARmonics:SETUp?
MANUAL The oscilloscope does not adjust the setup when entering or
exiting the harmonics measurement mode.
AUTOMATIC The oscilloscope adjusts various settings to optimize the
harmonics display. The oscilloscope returns to your previous settings
when you exit t he harmonics measurement mode.
Syntax
Arguments
Examples
Related Commands
Group
Syntax
Arguments
To Next Page
Loading...
