Command Descriptions
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
2- 141
HORizontal:VIEW
Specifies whether the horizontal display uses the Main, Window
Zone, or Window view. This is equivalent to setting the View in the
Horizontal menu.
Horizontal
HORizontal:VIEW { MAIn | WINDOW | ZONE }
HORizontal:VIEW?
MAIn specifies that the waveform is acquired and displaye d using the
Main time base.
WINDOW specifies that the waveform is acquired and displaye d using
the Window (delay) time base.
ZONE is the same as MAIn, but adds display of vertical cursor bars to
show the porti on of the waveform that would be acquired and
displayed using the window (delay) time base.
HORizontal:VIEW MAIn specifi es the default horizontal view.
ID? (Query Only)
Returns identifying information about the osc illoscope and its
firmware in Tektronix Codes and Formats notation.
NOTE. ID? must be the last command when part of a concatenated
statement. Otherwise the oscilloscope generates event message 440.
The ID? and *IDN? responses are slightly different.
Group
Syntax
Arguments
Examples
To Next Page
Loading...
