Tektronix TDS210 - Page 173

Command Descriptions
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
2- 153
MATH:FFT:VERtical:POSition 2
Sets the FFT waveform vertical position to 2 major divisions above
the center horizontal graticule line.
MATH:FFT:VERtical:POSition?
Might return 5, indic ating that the FFT waveform 0 reference point
is 5 major divisions from the center horizontal graticule line.
MATH:FFT:VERtical:SCAle
NOTE. You can use t his command with a TDS1000, TDS2000,
TDS1000B, TDS2000B, and TPS2000 oscilloscope, as well as a
TDS200 oscilloscope with a TDS2MM measurement module.
Sets or queries the FFT math waveform vertical zoom factor.
Math
MATH:FFT:VERtical:SCAle <NR3>
MATH:FFT:VERtical:SCAle?
<NR3> specifies the vertical zoom factor, where the axis of
magnification is the center horizontal graticule line. Valid zoom
factors are 0.5, 1, 2, 5, and 10. If other values are entered the
oscilloscope rounds the value of <NR3> to the nearest valid zoom
factor.
MATH:FFT:VERtical:SCAle 5
Sets the FFT waveform vertical zoom factor to X5.
MATH:FFT:VERtical:SCAle?
Examples
Group
Syntax
Arguments
Examples