Command Descriptions
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
2-49
ACQuire:NUMAVg <NR1>
ACQuire:NUMAVg?
<NR1> i s the number of wave form acquisitions. Correct values are 4,
16, 64,and128.
ACQuire:NUMAVg 16
This specifies that an averaged waveform will show the result of
combining 16 separately acquired waveforms.
ACQuire:NUMAVg?
Might return 64, indicating that there are 64 acquisitions spec ified
for averaging.
ACQuire:STATE
Starts or stops oscilloscope acquisitions. This command is the
equivalent of pressing the front-panel RUN/STOP button. If
ACQuire:STOPAfter is set to SEQuence, ot her signal events may
also stop acquisition.
NOTE. The best way to determine when a single sequence acquisition
is complete is to use *OPC? rather than ACQuire:STATE?. For more
information on the *OPC? command, refer to page 2--169.
Acquisition
ACQuire:STATE { OFF | ON | RUN | STOP | <NR1> }
ACQuire:STATE?
Syntax
Arguments
Examples
Group
Syntax
To Next Page
Loading...
Need help?
General
