Command Descriptions
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
2-59
*CAL?
0 indicates that the self-calibration completed without any errors
detected.
Any value other than zero indicates that the self-calibration did not
complete successfully or completed with errors.
*CAL?
Performs a sel f-calibration and might return 0 to indicate that it
completed successfully.
CALibrate:INTERNAL
CALibrate:ABOrt (S et Only)
NOTE. You should only use this command in a qualified service
environment. For more inf ormation about the fact ory calibration
sequence, refer to the service manual for your oscilloscope.
Aborts the fa ctory calibration process. When you abort the factory
calibration, the oscilloscope restores the calibration settings to the
previous factory ca libration constants stored in non-volatile memory.
Calibration and Diagnostic
CALibrate:ABOrt
CALibrate:ABOrt
Syntax
Returns
Examples
Related Commands
Group
Syntax
Examples
To Next Page
Loading...
Need help?
General
