Command Descriptions
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
2-71
CH<x>:YUNit
(TDS1000B, TDS2000B, and TPS2000 Series Only)
Sets or queries the units of the specified channel. The value of <x>
can vary from 1 through 4 for 4-channel instruments or 1 through 2
for 2-channel instruments.
Vertical
CH<x>:YUNit <QString>
CH<x>:YUNit?
<QString> is either “V” for volts or “A” for amps. This is equivalent
to setting the probe to Voltage or Current in the probe front-panel
menu. This command is case insensitive.
Examples
CH2:YUNIT?
Might return CH2:YUNIT “V”, indicating that the channel 2 unit s are
volts.
*CLS (Set Only)
The *CLS command clears the following oscilloscope status data
structures:
H The Event Queue
H The Standard Event Status Register (SESR)
H The Status Byte Register (except the MAV bit described on
page 2--72)
Group
Syntax
Arguments
To Next Page
Loading...
