Command Descriptions
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
2-75
CURSor:HBArs:DELTa?
<NR3>
CURSor:HBArs:DELTa?
Might return 5.08E0 for the difference between the two cursors.
CURSor:HBArs:POSITION<x>
Positions a horizontal bar cursor. The value of <x> can vary from 1
through 2.
NOTE. If Trigger View is active, the query form returns 9.9E37 and
generates event 221 (Settings conflict).
Cursor
CURSor:HBArs:POSITION<x> <NR3>
CURSor:HBArs:POSITION<x>?
<NR3> specifies the horizontal bar cursor position, relative to ground
(in volts when the units are volts and amps when the units are amps),
relative to the center of the screen (in divs when units are divisions),
or relative to 1 V RMS (in decibels when the source is an FFT math
waveform), for the waveform specifi ed by the CURSor:SE-
Lect:SOUrce command.
The cursor position is limited to the graticule whenever an attempt is
made to move it outside the graticule.
Syntax
Returns
Examples
Group
Syntax
Arguments
To Next Page
Loading...
