Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2- 107
DISplay:PERSistence { <NR3> | INFInite | AUTO | MINImum }
DISplay:PERSistence?
<NR3> specifies the time, in seconds, that waveform points are displayed on the
screen.
INFInite displays waveform points until a control change resets the acquisition
system.
AUTO specifies that the waveform persistence is controlled by the front panel
WAVEFORM INTENSITY knob.
MINImum specifies that the waveform persistence is set to the minimum value of
0.0E0.
DISPLAY:PERSISTENCE 3
specifies that the waveform points are displayed fading for 3 seconds before they
completely disappear.
DISplay:INTENSITy:WAVEform
DISplay:PERSistence:CLEAR (Set Only)
Resets the persist time countdown and clears the display of all acquired points.
This command is equivalent to pressing the Clear Persistence buttoninthe
Waveform Display menu.
Display
DISplay:PERSistence:CLEAR
DISPLAY:PERSISTENCE:CLEAR
clears the waveform display.
DISplay:PERSistence, DISplay:INTENSITy:WAVEform
Syntax
Arguments
Examples
Related Commands
Group
Syntax
Examples
Related Commands
To Next Page
Loading...
