Tektronix TDS3000 Series Program Manual

Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2- 209
MEASUrement:IMMed:DELay:DIREction
Sets or returns the starting point and direction that determines the delay “to”
edge when taking an immediate delay measurement. Use the MEASUre-
ment:IMMed:SOURCE2 command to specify the delay “to” waveform.
Measurement
MEASUrement:IMMed:DELay:DIREction {BACKWards | FORWards}
MEASUrement:IMMed:DELay:DIREction?
BACKWards means that the search starts at the end of the waveform and looks for
the last rising or falling edge in the waveform. The slope of the edge is specified
by MEASUrement:IMMed:DELay:EDGE2.
FORWards means that the search starts at the beginning of the waveform and
looks for the first rising or falling edge in the waveform. The slope of the edge is
specified by MEASUrement:IMMed:DELay:EDGE2.
MEASUREMENT:IMMED:DELAY:DIRECTION FORWARDS
starts searching from the beginning of the waveform record.
MEASUREMENT:IMMED:DELAY:DIRECTION?
returns either BACKWARDS or FORWARDS.
MEASUrement:IMMed:DELay:EDGE<x>
Sets or returns the slope of the edge that is used for the delay “from” or “to”
waveform when taking an immediate delay measurement. The waveform is
specified by MEASUrement:IMMed:SOURCE<x>.
Measurement
MEASUrement:IMMed:SOURCE<x>
MEASUrement:IMMed:DELay:EDGE<x> { FALL | RISe }
MEASUrement:IMMed:DELay:EDGE<x>?
Group
Syntax
Arguments
Examples
Group
Syntax

Tektronix TDS3000 Series Specifications

General

Brand	Tektronix
Model	TDS3000 Series
Category	Test Equipment
Language	English