Tektronix TDS3000 Series - Page 251

Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2- 213
MEASUrement:IMMed:UNIts? (Query Only)
Returns the units for the immediate measurement.
Measurement
MEASUrement:IMMed:UNIts?
<QString> returns ”V” for volts, ”s” for seconds, ”Hz” for hertz, ”%” for
percent, ”A” for amps, ”W” for watts, for ohms, ”dB” for decibels, ”?” for
unknown, and ””for non-dimensional units. Measurements on math waveforms
can return the following units: ”V/V”, ”A/W”, ”WV”, ”W/V”, ”dBV”, ”dB/V”,
”V/A”, ”A/A”, ”WA”, ”W/A”, ”dBA”, ”dB/A”, ”VW”, ”V/W”, ”AW”, ”A/W”, ”WW”,
”W/W”, ”dBW”, ”dB/W”, ”VdB”, ”V/dB”, ”AdB”, ”A/dB”, ”WdB”, ”W/dB”, ”dBdB”,
and ”dB/dB”.
MEASUREMENT:IMMED:UNITS?
might return ”s”, indicating that the units for the immediate measurement are
seconds.
MEASUrement:IMMed:TYPe
MEASUrement:IMMed:VALue? (Query Only)
Immediately executes the immediate measurement specified by the MEASUre-
ment:IMMed:TYPe command. The measurement is taken on the source specified
by a MEASUrement:IMMed:SOURCE command.
Measurement
MEASUrement:IMMed:VALue?
<NR3>
MEASUrement:IMMed:DATa?
Group
Syntax
Returns
Examples
Related Commands
Group
Syntax
Returns
Related Commands