Command Descriptions
2- 246
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
REBOOT (No Query Form)
Reboots (restarts) the oscilloscope firmware. This is the equivalent of power
cycling the oscilloscope.
Miscellaneous
REBOOT
*RCL (No Query Form)
Restores the state of the oscilloscope from a copy of its settings stored in
memory. (The settings are stored using the *SAV command.) This command is
equivalent to RECAll:SETUp and performs the same function as the Recall
Saved Setup item in the SAVE/RECALL menu.
Save and Recall
*RCL <NR1>
<NR1> is a value in the range from 1 to 10. A value of 1 to 10, specifies a saved
setup storage location.
*RCL 3
restores the oscilloscope setup from a copy of the settings stored in setup
location 3.
FACtory, *LRN?, RECAll:SETUp, *RST, *SAV, SAVe:SETUp
RECAll:MASK
(Requires TDS3TMT)
Loads the specified mask file from the disk or flash drive into the User mask.
Save and Recall
RECAll:MASK <QString>
Group
Syntax
Group
Syntax
Arguments
Examples
Related Commands
Group
Syntax
To Next Page
Loading...
Need help?
General
