Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2- 247
<QString> is the path and file name, enclosed in quotes, of the mask file to load
from the disk or flash drive into the User mask.
RECAll:MASK ”fd0:\custome2.msk”
loads the file custome2.msk from the floppy drive into the User mask.
SAVe:MASK <QString>
RECAll:SETUp (No Query Form)
Restores a stored or factory front-panel setup of the oscilloscope. This command
is equivalent to selecting Recall Saved Setup or Recall Factory Setup in the
SAVE/RECALL menu.
Save and Recall
RECAll:SETUp { FACtory | <NR1> | <file path> }
FACtory selects the factory setup. Initializes instrument settings to factory
defaults, excluding: GPIB, hard copy, RS232 parameters, file instrument setting
parameters, calibration notification time, battery off time, backlight time-outs,
and user’s language.
<NR1> is a value in the range from 1 to 10 and specifies a setup storage location.
<file path> is the name of the file where the setup will be recalled from.
<file path> is a quoted string that defines the file name and path. Input the file
path using the form <drive>/<dir>/<filename>. <drive> and one or more
<dir>s are optional. If you do not specify them, the oscilloscope will read the
file from the current directory. <filename> stands for a filename of up to 8
characters followed by a period (“.”) and any 3-character extension. Do not use
wild card characters.
The current directory refers to the name of a directory as returned by the
FILESystem:CWD command.
Arguments
Examples
Related Commands
Group
Syntax
Arguments
To Next Page
Loading...
Need help?
General
