TLA7000 Series Mainframe Technical Reference Manual
15
Benchtop Mainframe Removal and Installation Procedures
This section provides procedures for removing and installing mechanical and
electrical modules in the benchtop mainframe.
CAUTION. Before doing this or any other procedure in this manual, read the
General Safety Summary and Service Safety Summary found at the beginning of
this manual.
Equipment Required
Table 4 lists the tools needed to remove and replace components in the main-
frame.
Table 4: Equipment required t o service the mainframes
Item number Item Description
1 Flat bl ade screwdriver Small flat blade screwdriver
2 Cutters Diagonal cut ters (for removing cable ties)
3 Screwdriver handle Accepts Torx driver bits
4 T-7 Torx tip Torx drive bit for T-7 size screws
5 T-15 T orx tip Torx drive bit for T-15 size screws
6 T-20 T orx tip Torx drive bit for T-20 size screws
7 Allen wrench A 3/32-inch Allen wrench (hex wrench)
8 Phillips screwdriver Phillips #1 screwdriver
9 Cable ti es 4-inch tie-down straps (Tektronix part number
343-0549-00)
NOTE. When installing the screws, use a torque screwdriver and tighten the
screws to 8 in-lbs unless otherwise noted.
WARNING. To avoid electric shock, always power off the instrument and
disconnect the power cord before cleaning or servicing the instrument.
To Next Page
Loading...
Need help?
General
