Getting Started
Instrument opt
ions. Your instrument may have been ordered with one or more
options. (See Table 5.)
You can check w
hich options are o n the instrument after it is p owered on by
performing the following steps:
1. Press the CO
NFIG button on the front panel.
2. Use the General knob to navigate to Utilities.
3. Press the right arrow button to navigate to the Utilities submenu and select
View Instrument Options. The menu box on the right side of the display
shows the i
nstalled options.
Table 5: Instrument options
Option
Instrument
model Description
2SDI
WFM8200,
WFM8300
Adds support for second SDI board
in Slot 2 of the instrument rear panel.
With this option, this instrument can
monitor up to four SDI inputs. This
option is not compatible with Option
CPS.
3G
WFM8200,
WFM8300
Adds support for 3G-SDI signal
formats.
CPS
WFM8200,
WFM8300
Adds support for Composite Analog
Video Monitoring; 2 composite Analog
inputs; passive loop-through. This
option is not compatible with Option
2SDI.
Video
3D WFM8200,
WFM8300
Adds Stereoscopic 3-D Video
Monitoring Capabilities (including
Simultaneous Input Monitoring (SIM)
of dual SDI inputs and synchronized
left eye and right eye signals
monitoring (SyncVu™)).
6 WFM8200 and WFM8300 Waveform Monitors
To Next Page
Loading...
