Display Information
Pop-Up Menus
All pop-up menu
s are displayed by pressing and holding the specified display
button for three seconds. To hide a pop-up menu, press the specified button again.
Pop-up menus appear in the active tile and, in general, control only settings
specific that tile. A pop-up menu will not appear if it is not appropriate for the
current instrument setting (for example, trying to display the Gamut menu when
viewing a composite input signal).
To Set Displ
ay Para meters
Use the pop-up menus to set up the measurements that you display.
1. Select a tile by pressing one of the numbered DISPLAY SELECT buttons.
Figu
re 18: Using the Display Select buttons
2. Pres
s and hold the chosen display button and the display and the pop-up menu
for that display appears.
NOTE. The selections in a pop-up menu can change depending on settings.
3. Use the right and left keys to move between menu panels. The instrument
surrounds the panel selected with a blue border. (See Figure 19.)
4. Use the up and down arrow keys to select parameters in a menu. (See
Figure 19.)
34 WFM8200 and WFM8300 Waveform Monitors
To Next Page
Loading...
