Signal Inputs
Figure 14: Dual Link information placement in waveform display
Multi-Input Display Mode
The Multi-Input display mode supports the simultaneous display of up to four
SDI inputs of the same format. You can choose to view a s pecificstreamofa
multi-stream signal (such as a 2xHD Level B 3 Gb/s signal) or both streams
together. This mode is only available for use in the WFM, GAMUT,and
VECTOR displays.
To Turn On the Multi-Input
Display
Enabling the Multi-In
put display m ode is a two step process. The Multi-Input
menu option is only available in the WFM, GAMUT,andVECTOR pop-up
menus when the feature is enabled from the MAIN button m enu. To enable this
feature:
1. Press and hold the MAIN button.
2. Navigate to Multi-Input Mode.
3. Press the SEL button to highlight Enable.
4. Press the MAIN button to dismiss the menu.
The Multi-Input display mode is now enabled. The next step is to turn on the
feature in a given trace by doing the following:
1. Press and hold the WFM, VECTOR,orGAMUT button to get a display in a
tile and to view the pop-up menu for that display.
2. From the pop-up menu, select On for Multi-Input.
3. Press the FULL button to activate the full screen view of that display.
The Multi-Input display mode will now be active.
NOTE. The Multi-Input display may be selected for each tile individually, but it
will only be active when the tile is displayed full screen.
WFM8200 and WFM8300 Waveform Monitors 27
To Next Page
Loading...
