Getting Acquainted with Your Instrument
Layout and Usage
The primary fro
nt panel elements shown below are described in the table that
follows. The Usage procedure column in the table refers you to a procedure in
this manual that explains how to use the element. If there is no page reference, the
information given explains the basic function of the element.
Control element or group Usage procedures
Display selection buttons Press the numbered buttons to choose which
of the four tiles to activate. You can also
viewatilefull-screen by pressing the FULL
button.
Measurement buttons How to select a display using the
Measurement buttons (See page 33.)
Gain and Sweep buttons How to u se Gain, Sweep, and Magnification
(See page 89.)
Preset buttons How to use Presets
(See page 93.)
Input Selection buttons Selecting Signal Inputs (See page 22.)
Line Select button Setting Line Select Mode (See page 92.)
EXT REF button
External Reference (See Figure 16.)
Timing a Studio (See page 165.)
Capture button Capturing the Display (See page 91,
Capture.)
Help button
Online Help (See page 17, To Navigate
Online Help.)
Cursor button Measuring Waveforms with Cursors (See
Figure 49.)
16 WFM8200 and WFM8300 Waveform Monitors
To Next Page
Loading...
